2271A Embedded Software, Update by USB

TITLE	USE WITH
2271A	2271A
The updating of embedded software should only be performed after given specific instructions to do so from Technical Support or a Fluke Calibration Authorized Service Center. If the update isn't performed properly, your product may be inoperable until it is.
Instructions to update by the USB port on the rear panel of the 2271A
Begin by clicking on the Get software button. Then download the zip file by clicking the 2271A v102 USB.zip button. Extract the four files to a location on your computer: 2271A_main 2271A_gui Script2271 Script6270 Connect a USB cable to the back panel USB connector on the 2271A and to the computer. On the computer, drag and drop (or copy and paste) the downloaded file(s) from the computer to the drive letter of the 2271A. **NOTE: It’s best to always update all firmware files. The 2271script file must always be used. Wait at least 1 minute, then turn off the 2271A controller by the main power switch on the back panel. Leave it off for one minute then turn it back on. Wait for the controller to completely power up to the main screen, then go to the ‹Setup›, ‹Instrument Setup›, ‹About This Instrument› screen and verify that "Revision" is correct. Press ‹Exit› to return to the main screen. More detailed instructions are on our Online Help Center.
Updates Include:
Main Version 1.02 (2018 March) Add: Support PM500 Pressure Measurement Modules, and zeroing of low absolute models
GUI Version 1.02 (2018 March) Add: Update for main firmware changes
PCM Version 1.01 (2017 September) Fix: Prevent overshoot of next pressure set point after venting
Main Version 1.01 (2016 June) Add: HART improvements
GUI Version 1.01 (2016 June) Change: Update for main firmware changes
Main Version 1.00 (2016 April) Initial release
GUI Version 1.00 (2016 April) Initial release

||||